Marinews
Login | Contact Us | Site Map | Link to Site   
Marinews
MARINEWS
   
BOATING
   
FISHING
   
EXPLORING
   
FORUM
   
WEATHER
   
TRAILERBOAT FISHERMAN
   
AUSTRALIAN BOATING
   
JUST FOR FUN
   
LOGIN
   
CATALOGUES
   
CONTACT US
   
SITE MAP
   


 

Texposed


Also known as: Jig Head
 
 
Copyright @ Marinews Pty Ltd 2008 . All Rights Reserved. All material displayed is the property of Marinews Pty Ltd. All copyright violation will be dealt with firmly. If you suspect our copyright has been violated, please email: copyright@marinews.com Thank you.
 
Glossary   A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z
 

Texposed

As simple as this rig looks, it's critical to get it exactly right. Scrunched, bent or twisted tails don't swim properly, often spin in the water, causing line twist, and will deter fish from biting.
This is the most basic of all rigs for soft plastics, and also arguably the best.
Begin by laying the jig/hook alongside the soft plastic, with the nose of the soft plastic held level with the back of the jig head. Note exactly where the bight of the jigs hook comes to on the back (top) of the soft plastics tail. This will be the exit spot for the hook point to exit.
Push the point of the jig hook into the front of the soft plastic lure, in the centre of its head or nose. Thread the soft plastic lure onto and around the hook bend so that the point of the hook exits the back of the  plastic exactly on the centre line and at that point you noted earlier. Snug the nose of the plastic up against the back of the jig head and glue if preferred.
If your  lure  looks  neat on the hook and the point comes out dead on the centre line of the plastic's back, you probably have it right. If it looks in any way dodgy, slightly crooked, bent, skewed or bunched up, do it again!
Drop the lure in the water and check its action. Pulling it along for a metre checking its action is strongly advisable. If the plastic swims straight on the test run, the tail wobbles or kicks enticingly, and the lure looks like something that might actually be alive, then you've rigged it properly.
With all flick or stick bait style of soft lure, the rigging method is exactly the same, but you need to actually cast the lure a couple of metres and work it back with a few pauses and flicks from the rod tip checking it kicks and flashes and jinks and darts—looking like a wounded, dying bait fish.
Marinews | Boat Test | Boating Articles | Exploring Articles | Fishing Articles | Knots | Rigs | Links | Forum